Filter
Top Products
Contents
PARTSAND FEATURES
BEFORE YOU USE YOUR
AIR CONDITIONER.
Energy Saving TIPS
HOW TO START & USE
YOUR AIR CONDITIONER
Page
2
2
3
Page
Cleaning Filter .5
Annual Maintenance. .5
Do-It-Yourself Maintenance
.5
Oilinq The Fan Motor. 6
3
IF YOU NEED SERVICE
OR ASSISTANCE
7
To Start Your Air Conditioner
3
1, Before Calling For Assistance
.7
Using Exhaust Vent Control 4
2. If You Need Assistance
.7
Changing Air Direction
4
3. If You Need Service .7
CLEANING 81 CARING FOR YOUR
AIR CONDITIONER.
5
4. If You Have A Problem .7
Cleanrng Front Panel
5
5. If You Need FSP”
Replacement Parts
.7
c 1967 Whirlpool Corporation
Parts and Features
Copy your Model and
Serial Numbers here.. .
When you need service or call with a question,
have this information ready.
1.
Complete Model and Serial Numbers.
To find Model and Serial Numbers remove
the front panel (see page 5). The numbers
are located on a label attached to the
evaporator coil cover near the top of the unit.
SERIAL LABEL
2. Purchase date from sales slip.
Copy this information in the spaces below.
Keep this book, your INSTALLATION
INSTRUCTIONS, and your sales slip
together in a handy place.
Model Number
Serial Number
Purchase Date
Service Company Name and Telephone Number
BEFORE YOU USE YOUR
AIR CONDITIONER
Read and carefully follow the “INSTALLATION
INSTRUCTIONS” included with your air conditioner.
Read this Use & Care Guide carefully for important use
and safety information. Save it for future use in case
you may have a question or move the air conditioner.
It is your responsibility to make sure
that your air conditioner:
l
Has been properly installed.
l
Is the right size for the area you want to cool.
l
Has been properly connected to electrical
supply and grounded. (See INSTALLATION
INSTRUCTIONS.)
l
Is properly used only for the job for which it was
designed.
l
Is not used by anyone unable to operate it
properly.
l
Is properly maintained.
To remove the Consumer Buy Guide label and energy
rating label lift one edge and pull straight off.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then remove.
-OR-
2. Soak area with a lrquid hand dishwashing detergent
before removing glue as described in step 1.