Filter
Top Products
3. insert finish frame into wail opening.
Square and level the frame. Nail frame
securely to the wall studs.
4. Remove the ground wire and screw
from the front of the unit base. Save
grounding screw for reattachment in
Step 13.
5. Slide unit out of cabinet. Grasp handle
and slide unit straight out of cabinet.
Place unit on cardboard to protect your
floor covering.
6. insert cabinet into the wail opening.
The top of the cabinet should extend W
(13 mm) into the room. If there is trim, the
cabinet should extend W’ (13 mm) past
the trim.
7. Check the outward slope of the cabi-
net. Place a carpenter’s level inside the
cabinet on the right side. There should be
l/2 bubble (%” [6 mm] per foot [30.5 cm])
slope toward the outside. Also check the
left side.
NOTE: Make sure the air conditioner
cabinet has the proper outward slope so
condensate water runs to the outside or
damage could result to the floor or wall.
8. Seal opening between cabinet and
finish frame. Use the insulation removed
in Step 1.
9. Attach cabinet to finish frame. Use #lO
x 1” (25 mm) wood screws (not supplied)
to attach cabinet to the frame.
IMPORTANT: Do not over-tighten screws
or the cabinet will distort and provide a
poor air seal between the cabinet and the
air conditioner.
14