Filter
Top Products
C&ii:: Your Air Conditioner
Electrical Shock, Product Damage and
Personal Injury Hazard
l
Unplug Power cord from receptacle
before performing any maintenance. Be
sure no liquid gets into the motor,
electrical control box or compressor
electrical terminals.
l
Do not lift, push or pull any white beaded
foam (expanded polystyrene) parts.
l
Because your air conditioner weighs from
80 to 200 pounds, ft Is recommended that
you have someone help you when you
remove and re-install your unit and that
you both use proper lifting techniques.
l
Handle the air conditioner with care.
Watch out for the sharp metal fins on the
front and rear coils.
l
Do not use the collected water for
drinking purposes. lt is not sanitary.
Failure to follow the above precautions
could result in electrical shock, product
damage or personal injury.
1. Unplug power cord.
2. Remove front panel. (See page 5.)
3. Slide unit out of cabinet by using the handle in
the center of the base flange.
4. Wrap the motor, connector plug, electrical
control box and compressor terminal box in
plastic film and make sure no water or other
liquid gets inside any of these parts. It could
damage the insulation and cause serious
mechanical problems.
Handle
5. Carefully clean and hose out the base,
condenser coil and condensate pans. Clean at
least once a year or more often if the con-
denser coil and pan collect din, sand, leaves,
insects or algae. Also, clean if you detect an
odor coming from the air conditioner.
6. Remove plastic film from motor and electrical
parts.
7. Replace unit in cabinet.
6. Replace front panel.
9. Reconnect power supply.
NOTE: It is a good idea to wait 24 hours before
starting the unit again. This allows time for all
areas to dry out. The water from rainfall or from
normal operation does not harm these
components.