Filter
Top Products
Now start...
With pump in room where it
will be installed.
1
. Determine where you wish to
locate water pump and water
bottle. The water bottle and water
pump should be installed on the same
level.
The water bottle and water pump must
be located close together since the
tubing connecting the pump to the
water bottle is 1.8m (6 feet) long. Use
existing tubing between water pump
and water bottle. Do Not cut this tubing
or add tubing between pump and water
bottle. Do Not remove clamp on end of
tubing that connects inner tubing to
outer tubing.
Suggested locations:
l Under the sink .
l Cabinet next to refrigerator.
2
Determine where you will need
. to run water lines and the
length of tubing that will be
needed. If more tubing is needed than
what is supplied, tubing (Part No.
4319151) and tubing connectors (Part
No. 4319153) can be obtained from
your dealer or authorized parts
distributor.
3
Attach bottle cap to water
’ bottle. Push the tubing into the
water bottle until the end of the tubing
reaches the bottom of the bottle. Do
Not remove clamp from end of tubing.
4
, Insert one end of the outlet
tubing into connector located
on outside of pump as far as it will go, If
tubing needs to be adjusted, push
connector in and pull tubing out.
5
Route the tubing to the
refrigerator. Cut tubing to
’ length needed.
6
Plug power supply cord into
’ earthed, electrical outlet. Press
the pump switch to the “I” position.
connector
tubing
collet
7
, Run enough water through
refrigerator to fill a glass or other
container. Check all connections for
leaks.
If a connection leaks, push in collet and
remove tubing. Cut off 1.3cm (l/2”) of
tubing and reinsert into connector.
If unit is connected ONLY to a
refrigerator icemaker, the icemaker will
have to call for water before pump can
be checked for leaks.
Information
The water pump operates
automatically when dispenser is
operated. When the dispenser is
released, the water pump
automatically stops operating.
When water bottle empties
during use:
Pressurized air is expelled
through dispenser when water bottle is
empty.
1
Stop dispensing from the
’ refrigerator.
2
n
3.
bottle
bottle
Press the switch on the
water pump to the “0”
position.
Remove bottle cap from water
bottle. Replace empty water
Attach bottle cap to full water
Press the switch on the water
pump to the “I” position.
If water bottle empties while
unattended,
the pump will run for
2-l /2 minutes and then automatically
shut off.
1.
2.
bottle.
bottle.
3.
Press the switch on the water
pump to the “0” position.
?emove bottle cap from water
mottle. Replace empty water
Attach bottle cap to full water
Press the switch on the water
pump to the “I” position.
If water system is exposed to
temperatures below 0°C (32’F),
the system must be drained.
Remove tube from bottle. Open all
outlets and run pump to inject air
through all outlets.
Cleaning and sanitizing system:
System should be cleaned after
extended periods of non-use.
1
n
2.
3.
4,
Add one-half teaspoon of
chlorine bleach to one gallon of
water.
Inset-t tube into solution and start
w-w
Open all outlets to fill system with
solution. Let stand five minutes.
Flush system with water until
chlorine is removed.
Panel B