Filter
Top Products
Now start...
Wii air conditioner in room where it will
be installed
10
n
Insert other filler board into
window channel on opposite side of
cabinet. Push filler board against side-
mounting angle and attach with
12.5 mm (l/2”) hex-head screws.
Raise window sash.
WINDOW INSTALLATION
11
n
From the outside, push filler
See Panel C for Through-thewall
installation.
Front view 01 unil with front panel removed.
/ angle-
boards as far forward in window
channels as possible.
12
n
Measure the
distance between the
channel edge and
the filler board. Cut
foam blocks 6.4 mm
(l/4”) wider. Insert
blocks into channel
behind filler boards.
5
side view
n
Place cabinet in window. Lower
sash (window frame) to hold cabinet in
place. Measure the distance between
the side of the cabinet and inside of the
window channel at the top and bottom
of the cabinet. Adjust the cabinet until
the distance on each side (top and
bottom) is the same, so the cabinet is
centered in the window. Write down the
final measurement.
Dower-
c&b .
1
n
Loosen, but Do Not remove
grounding wire screw. Disconnect
grounding wire.
+A2+
;cAl --,
+
I I
I I
I I
+
I I
13
n
Measure from inside edge of
I I
right
I
tiller
I
: left
board :
I tiller
I board
window frame to other inside edge. Cut
foam seal with square ends to fit.
Align foam seal with front edge of
window sash and attach seal with
adhesive side against underside of sash.
Floor Damage
Remove air conditioner from carton
and place on cardboard.
Failure to do so may cause damage
to floor covering.
I I
I
I
I I
I
I
I I
I
I
t
I
I
e 82
4
I
I
+ 81
6
n
Add 3.2 mm (l/8”) to both open
area measurements. Use utility knife to
Q
mounting
angle
0
&
\
seal
-
Property Damage
Check that air conditioner cabinet is
tilted to the outside so that water will
run to the outside.
Failure to do so may cause damage
to floor covering, window sill or wall.
cut filler boards to fit.
back of
filler
board
.
7
left
tiller
board
.
2
n
Attach 9.5 mm
(3/8”) seal strip to the
bottom of both side
mounting angles (side with two holes).
Cut strips to length.
ri ht
fil er
7
board
.
7
front of filler board
4
n
Apply 9.5 mm (3/8”) seal strips to
bottom and outside of filler boards. The
top seal goes on back side of filler
boards.
on both sides.
14
n
Lower window sash. Place
level inside cabinet on the right side.
There should be a tilt to the outside of
approximately one bubble. Place the
level on the left side and check.
3
n
Attach side-mounting angle with
15
n
Use a 2.4 mm (3/32”) drill bit to
drill starter holes in the cabinet and into
the window sill. Fasten cabinet to the sill
with two wood screws.
two, hex-head, metal screws using
6.4 mm (l/4”) socket and socket wrench
or l/4” nut driver.
8
w Pull
cabinet part
way
out of window.
Attach one filler board
w
to front of a sidemounting
angle with 12.5 mm (l/2”) hex-head
screws.
4
n
Pull on handles; slide air
conditioner out of cabinet and place
on cardboard.
9
n
Place cabir
let back into the
window with filler board tight against
window channel.
Panel B