Filter
Top Products
4
Insert the frame in the wall
n
opening, Square and level
frame. Nail frame securely to the
wall studs.
K
Remove air conditioner and
ti
l
front panel from carton.
Personal Injury/Product
Damage Hazard
l
Maintain a firm hold on the air
conditioner to prevent it from
falling out of the opening
-during installation.
Failure to follow this instruction
could result in personal injury or
damage to the air conditioner.
air conditioner
frameT
6
Place unit in center
. of opening.
7
Place level on air
n
conditioner in openinq.
There should be a tilt t6 the -
outside of about one bubble.
The air conditioner should be
level from side to side.
air conditioner
fram<.
8
Secure air conditioner in
n
opening. Go to Step 9.
tab
tront panel
9
lik
screw
Remove sheet metal
n
screws from front base
flange. Insert tabs on the top
edge of front panel into slots in the
air conditioner cabinet. Use two
screws to attach the bottom of
the front panel to the cabinet.
10
Use insulation to seal
n
opening between
cabinet and frame. Caulk outside
wall openings around cabinet.
11
If needed, install
n
moldina around
room side of cabinet.
Wall/Floor Damage
Check that air conditioner is
tilted to the outside so that
water will run to the outside.
Failure to do so may cause
damage to wall/floor coverings.
Pcirt
No. 1157672 Rev. D
Prepared by Whirlpool
Corporation,
t’ 1902 Whirlpool CorL>cJrcJtiorl
Benton Harbor, Michigan 49022
1
Remove the rear grille from
n
the air conditioner and
discard the grille.
~;--~
cabinet
flange
Place the foamseal between the
front edge of the air conditioner
base and the bottom flange of
the cabinet.
2
Install the sleeve by
n
following the installation
instructions that came with it.
3
Follow THROUGH-THE-WALL
n
INSTALLATION, Steps 9
through 11 to complete installa-
tion.
If your air conditioner is
not operating properly...
Check that the circuit breaker is
not tripped or house fuse blown.
Check that power supply cord is
securely plugged into the
electrical outlet.
If you need assistance...
The Whirlpool Consumer Assistance
Center will answer any questions
about operating or maintaining
your air conditioner not covered in
the Installation Instructions. The
Whirlpool Consumer Assistance
Center is open 24 hours u day, 7
days a week. Just dial (800) 253-l 301
-the call is free. When you call, you
will need the air conditioner model
number and serial number. Both
numbers are found on model and
serial label located behind the front
panel on the base flange.
Printed in U.S.A.