Filter
Top Products
Before you
Grounded electrical outlet within
reach of the power supply cord IS
start.. .
required. See Electrical
requirements.
ProDer installation is vour
responsibility. Make sure you have
everything necessary for correct
Important: Observe all
installation. It is the customer’s
governing codes and
responsibilitv to comDlv with the
ordinances.
installation specific&i&s
provided.
7/o ly\
7
opening size
Electrical outlet must
be available within
the reach of the
Do Not use an
extension cord.
Check location where air
An electrical outlet must be
conditioner will be installed for
available within reach of the
opening size, electrical outlet, and
service cord. DO NOT USE AN
airflow.
EXTENSION CORD.
The opening dimensions must
have a 24-7/8” width and 15-l j4”
height.
Electrical Shock Hazard
It is the customer’s responsibility:
Electrical Code, ANSI/NFPA 70-
* TO contact a qualified electri-
latest edition, and all local
cc11 installer.
codes and ordinances.
l
To assure that the electrical
Failure to do so could result in
installation is adequate and in
fire, electrical shock or other
conformance with National
personal injury.
Personal Injury/Product Damage Hazard
l
Because of the weight and size
conditioner to prevent it from
of the air conditioner, more
falling out of opening during
than one person is needed to
installation.
move, lift and safely install it.
l
Do Not locate air conditioner
l
Handle air conditioner with
where cabinet front is exposed
care. Metal fins on front and
to a heat source that raises the
rear coils are sharp.
surface temperature above
l
Do Not drink the water that
120°F.
collects inside the air condi-
Failure to follow these instructions
tioner. It is not sanitary.
l
Maintain a firm hold on the air
could result in personal injury or
damage to air conditioner.
Page 2
Tools and
materials
needed for
installation:
Order Through-the-Wall
Mounting Kit, Port No.
1158268 from authorized
parts distributor.
Electrical
requirements
Electrical Shock Hazard
l
Electrical ground is required
on this appliance.
l
Do Not modify the power
supply cord plug. If it does not
fit the outlet, have a proper
outlet installed by a qualified
electrician.
. Do Not have a fuse in the
neutral or grounding circuit.
A fuse in the neutral or
grounding circuit could result
in electric shock.
l
Do Not use an extension cord
with this appliance.
l
Check with a qualified
electrician if you are in doubt
as to whether the appliance is
properly grounded.
Failure to follow these insfructions
could result in serious injury or
death.
If codes permit and a separate
grounding wire is used, it is
recommended that a qualified
electrician determine that the
grounding path is adequate.