Filter
Top Products
ENGLISH
INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
DANGER:
HEALTH
HAZARD
This appliance must be
properly ventilated. Failure to
provide and maintain proper
ventilation of exhaust gasses
can result in severe injury or
death.
WARNING:
FIRE HAZARD
Do not store gasoline or
any other flammable or
combustible material near this
appliance. The open flame
can cause such materials to
ignite.
The area where the hotplate is
installed must be kept clear of
combustibles and flammables.
This includes mops, rags,
grease, wrapping paper and
electric cords.
NOTICE: Manufacturer’s
warranty on this hotplate is in
effect only when the hotplate
is installed in accordance with
these instructions and local
codes and ordinances or, in
the absence of local codes,
the National Fuel Gas Code,
ANSI Z223.1 (current edition).
The manufacturer of this
hotplate assumes no liability
for any damage or injury
resulting from failure to
comply with this notice.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
appliance before connecting performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
COMPONENTS
Cooking Grate (-1230G, 1 ea.; -2430G, 2 ea.;-3630H, 3 ea.)
Front Burner (-1230G, 1 ea.; -2430G, 2 ea.;-3630H, 3 ea.)
Rear Burner (-1230G, 1 ea.; -2430G, 2 ea.;-3630H, 3 ea.)
Adjustable Legs (set of 4)
Drip Tray, 1 ea.
SETUP
This appliance is designed for use in non-combustible locations
only. Setup the hotplate only on a firm, level, non-combustible
surface.
Verify local codes for requirements. Concrete, tile, terrazzo or metal
surfaces are recommended. Metal or tile over combustible material
may not meet code for non-combustible surfaces.
Clearances to non-combustible surfaces must be maintained.
Maintain 0” from side and rear to non-combustible walls, and 4” from
non-combustible counter as established by provided 4” legs.
Maintain adequate clearances for cleaning and proper operation.
The hotplate must be installed in an area with sufficient make-up air
for proper combustion, and must be installed such that the flow of
combustion and ventilation air will not be obstructed.
For servicing, Wells Mfg. recommends 6” clearance from rear of the
appliance to wall.
Install adjustable legs, one on each corner of
the appliance, in the holes provided. Verify
that the unit sits firmly ON ALL FOUR LEGS.
With the adjustable legs, adjust as required
to level the appliance. All four legs must be
adjusted to firmly contact the floor in order to
prevent tipping.
When used with an exhaust fan, special precautions must be
observed to avoid interference with the operation of the hotplate, such
as drafts and air starvation.
4
226 306627 OpManual for HDHP-Series Hot Plates