Filter
Top Products
ENGLISH
WARNING:
FIRE HAZARD
NEVER attempt to force
or repair a stuck control
valve.
Contact your Authorized
Wells Service Agency for
repairs.
Forced or improperly
repaired valves pose the
risk of fire and/or
explosion.
WARNING:
FIRE AND
EXPLOSION
HAZARD
If the pilot light should be
extinguished, turn off the
gas shut-off valve and
remove the grate and drip
pan. Allow the appliance
to vent for five minutes
before attempting to
re-light.
CAUTION:
HOT SURFACE
Exposed surfaces can be
hot to the touch and may
cause burns.
OPERATION (continued)
OPERATION
Inspect the unit for cleanliness before use. Clean as necessary: See
Cleaning Instructions, page 11.
Be sure the pilot light is lit before operation. See Lighting the Pilot
Light, page 8.
The burner control knobs must be turned by hand only. Never use
tools to turn the control knob.
The control used in this gas hotplate provides a continuous range of
settings from OFF to ON.
The right knob controls the front burner
The left knob controls the rear burner
Light the burner by turning the control knob to the ON position until fire
forms completely around the inner and outer sections of the burner.
Set the control knob to the desired position. The setting can be
readjusted at any time.
Cooking Recommendations:
Save energy by turning the temperature control knob OFF any time the
hotplate is not in use. Gas burners provide full heat instantly, making it
unnecessary to leave the unit on during intermittent use.
Fig. 4 Burner Control
9
226 306627 OpManual for HDHP-Series Hot Plates