Filter
Top Products
HearthStone Quality Home Heating Products Inc ® Model 8220
15
Tee Support Bracket
Adjustable Roof
Wall Strap
Chase Enclosure
Chimney Sections
Flashing
Storm Collar
Chimnet Cap
Chimney through outer wall with enclosed chase.
Starter section
Collar with built-in
Support Box and Trim
Two story house installation with attic.
Firesafe Enclosure
Firestop Radiation
Adjustable Roof
Chimney Cap
Wall Thimble
Tee
Stovepipe
Attic Insulation Shield
Chimney Sections
Twist-Lock
Support Bracket
Extended Roof
not included)
(Conduit
Flashing
Storm Collar
or other Lined Masonry Chimney
Tee
Chimney pipe through Clay tile
section
Adjustable Roof
Flashing
Storm Collar
Chimnet Cap
Starter
with built-in
Support Box
One story house installation with attic.
Access door
Tee clean-out
other Liner
Clay tile or
Shield
Wall Thimble
Stovepipe
Shield
Insulation
Access door
Masonry Chimney
Chimney Sections
Tee clean-out
Adjustable Roof
Flashing
Storm Collar
Chimnet Cap
Chimney is supported by Tee Support Bracket.
Chimney is supported by Ceiling.
Whenever possible, choose an interior chimney.
An interior chimney heats up more quickly and
retains its heat; thus promotes a better draft and
discourages the formation of creosote. An
exterior chimney does not benefit from the
warmth of being surrounded by the building, so
it typically operates at lower flue temperatures
than an interior chimney. An exterior
chimney’s draft is not as strong and may
experience increased creosote accumulation.
REVERSAL OF THE FLUE COLLAR
In order to reverse the flue collar to vent the
stove straight out the back, follow these simple
steps;
1) Using a 10mm wrench, or socket. Locate
and remove the four bolts holding the
flue collar in place. Once all four bolts
are removed pull the collar away from
the stove. Inspect the gasket, ensuring it
is in place, and in working order.