Filter
Top Products
7
Side Burner Maintenance
ṇWARNING: All gas controls and supply valves should
be in the OFF position.
Check igniter: Remove side burner cover. To remove side
burner cover, remove control knob and screws that hold
cover to bottom. Figure 14. Make sure wire is connected
between igniter and electrode. Check that igniter lock nut
is tight. Figure 15.
Note - If the igniter works loose, carefully tighten the
igniter lock nut with an adjustable wrench or pliers.
Adjust igniter electrode. Gap should be 1/8 to 3/16 inch
from tip of electrode to burner. Figure 16. Spark should be
a white/blue color, not yellow.
Figure 14
Figure 15
Figure 16
Venturi/Burner
Electrode
Igniter wire
1/8 to 3/16
inch gap
Igniter