Filter
Top Products
3
INTRODUCTION
This manual's main function is to assist the installer in correctly mounting doors with due regard for safety,
operation, and sound construction practices. Reference must be made to construction codes in your area.
All Wayne-Dalton DS-350 Windload Rated Commercial Roll-Up Doors follow the general instructions contained
herein. Additional installation information for the specific door shipped is found with the packing slip and on
supplementary drawings. There are also bolt and small sealed parts bags with accessory lists, describing proper
application.
PREPARATION
Read the installation instructions thoroughly to become familiar with the names of the various components and their
relation to each other. It is necessary for the installer to determine the following:
Method of operation (push-up, hand chain, or motor operated).
Type of jamb (masonry or steel) on which the door mounting angles mount and the fasteners required.
The dimensions for the opening width, opening height, headroom, and side room.
MATERIAL
Inspect your door for possible damage or shortage of parts. Report any shortages to your door supplier immediately,
or transit related damage claims to your freight carrier.
CLEARANCES
Check the door opening dimensions and available clearances versus the dimensions listed on the packing slip. Be
sure that the dimensions are correct for the opening you are working on, taking special note of the opening width
and height. Be sure that the required clearances listed on the Dimension Tables in this manual are available prior to
installation.
TOOLS
The tools recommended for proper installation of each door will vary, but commonly used tools are:
Electric drill with 3/8" or 1/2" chuck with nut driver bits
Masonry drill or impact hammer and bits.
Chain hoist and sling for raising barrel and curtain assembly.
Scaffolding, Mechanical Lift, and/or Ladders (ladders not recommended for larger doors).
Hammer.
Channel Lock Pliers
Center punch.
Screwdrivers.
Drills.
Wrenches, vise grips, C-clamps, torque wrench, and a large pipe wrench.
Plumb line, tape measure, chalk line, and a water level.