Filter
Top Products
Tools Needed:
12
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
Position the horizontal angle as shown.
Place tabs of horizontal angle in the
key slots of horizontal track. Using
a hammer, tap the horizontal angle
towards the curved end of the track until
the holes in track and angle are aligned.
Set tracks aside.
NOTE: For larger doors, a full length
horizontal angle may be spot welded to
the horizontal track. If the horizontal angle
is not welded, the horizontal angle will be
installed as shown.
Horizontal Angle
Hammer
HORIZONTAL
TRACK
HORIZONTAL
ANGLE
HORIZONTAL ANGLE
HORIZONTAL
TRACK
HOLE
HOLE
TABS
KEY SLOT
3
HORIZONTAL
TRACK
TABS
HORIZONTAL
TRACK
HORIZONTAL
ANGLE
HAMMER
HOLES
ALIGNED
Attaching Fully Adjustable
Flagangle to Vertical Track
1/4”- 20
FLANGE HEX
NUTS
NOTE: If quick install flagangle was
installed in Step 1, skip this step and
continue with Step 3. If not, complete
this step.
Hand tighten the flagangle to the vertical
track using (2) 1/4” - 20 x 9/16” large
head ribbed track bolts (or stud plate if
included) and (2) 1/4” - 20 flange hex
nuts. Repeat for other side.
Secure the flange nuts after flagangle
spacing is complete (Step 12).
FULLY ADJUSTABLE FLAGANGLE
1/4” - 20 X 9/16”
LARGE HEAD RIBBED
TRACK BOLTS
None
VERTICAL TRACK
2
STUD PLATE
(IF INCLUDED)