Wayne-Dalton 3222C-Z Garage Door Opener User Manual


 
1. Open and Close Cycle Control:
Allows garage door to be started and stopped by push button,
transmitter or wall station. The next impulse sends a stopped garage
door in opposite direction.
2. Emergency Disconnect:
Manual disconnect permitting operation of door during power failure
with automatic reconnect when opener is reactivated. See page 27.
3. Opener light:
Automatically turns on when opener is activated and remains on for
four minutes for convenience and safety.
4. Mechanical Door Lock:
When properly adjusted, opener locks door in closed position
preventing unwanted entry. See Adjustment # 3 on page 32.
5. Obstruction Warning Light:
The convenience light will fl ash after sensing an obstruction in the
down direction and/or if the safety system malfunctions while in the
open position.
6. Motor:
Permanently lubricated, thermally protected, heavy duty motor with
automatic reset.
System Features
7. Safety System:
Independent up and down force adjustments. When properly adjusted,
the safety system will automatically reverse the door when obstructed
in down direction and return to fully open position. The door will stop
when obstructed in the up direction. See Adjustment #2 on page 32.
8. Infrared Safety Sensors:
Wired infrared safety sensors detect an obstruction in door path and
react by reversing door.
9. Multi-Function Wall Station:
Wired wall station provides up/down door motion control and
independent overhead light on/off control. Wireless multi-function wall
station provides up/down door motion control, independent overhead
light on/off control, door down delay, adjustable “pet position” function,
and “pet position” program button.
10. Homelink
®
Compatibility:
Opener is capable of “learning” automobile equipped Homelink
®
transceivers. Visit: www.homelink.com.
11. Rolling Code Technology:
Wireless transmitters, multi-function wall stations and wireless keyless
entry use rolling code which prevent would be thieves from “grabbing”
the transmitter’s digital code.
Tools Needed
Safety Glasses
Phillips Head
Screwdriver
Non-Metallic
Step Ladder
Ratchet Wrench
7/16” Wrench
5/64”, 3/32”, 1/8”, 3/16”
Drill Bits
1/4”, 3/8”, 7/16”,
1/2”, 9/16” Sockets
Flat Tip
Screwdriver
Level7/16” Socket Driver
Pliers/Wire Cutters
Tape Measure
Pencil
Power Drill
Adjustable Wrench
Hacksaw
Pliers
2 x 6 x 12 Solid Test
Object
2 x 4 Board
Needle Nose Pliers
Hammer
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
IV