Wayne-Dalton 3222C-Z Garage Door Opener User Manual


 
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
18
23
Programming Wireless Keyless
Entry (If Included)
Tools Needed:
None
FORCE ADJ.
STATUS
SW
PROGRAM
Program Status
LED
Program
Button
Right Side Of Opener
Keyless Entry
DURING PROGRAMMING THE GARAGE
DOOR MAY OPERATE. KEEP PEOPLE AND
OBJECTS CLEAR OF THE MOVING DOOR
TO PREVENT DOOR DAMAGE OR
POSSIBLE PERSONAL INJURY.
NOTE: To simplify installation, program the wire-
less keyless entry to the opener before mounting
to the wall.
NOTE: Before programming ensure garage door
is in the “down” position.
1. Press and release the PROGRAM button. The
red PROGRAM STATUS light on the opener and
the overhead lamp will turn on and remain lit for
one minute, indicating that it is ready to learn the
keyless entry.
2. Press the desired five digit PIN (PERSONAL
IDENTIFICATION NUMBER), example 1-3-8-2-5.
The PROGRAM STATUS light will turn on and off
three times indicating a successful learn.
NOTE: Do not set a code that presents the num-
bers in sequential order, as an example 1/2, 3/4,
5/6, 7/8, 9/0. Studies show that people naturally
press the buttons in a sequential pattern. Also,
do not select a code that uses the same button
five times consecutively. Thieves can easily
figure out these types of codes.
NOTE: If at anytime, an error was made entering
the code, simultaneously press and release the
7/8 and 9/0 buttons to reset the keyless entry;
then repeat programming steps above.
NOTE: A single wireless keyless entry device may
be programmed to operate multiple garage door
openers. To program additional openers, repeat
programming steps using a different five digit PIN
for each additional opener.
How Your Keyless Entry Operates Your Door:
The following explains how your Keyless Entry
can be used to OPEN, CLOSE, START, and STOP
your door.
1. Enter your 5-digit PIN (personal identification
number); door will move.
NOTE: If you inadvertently enter an incorrect
code, the door will not move. To reset,
simultaneously press and release the 7/8 and
9/0 buttons and reenter your PIN number.
2. Unit remains active for next 25 seconds.
Pressing any key, will stop the door if opening,
and stop or reverse the door if closing during the
25 seconds active period.
WARNING