Filter
Top Products
Table of Contents
Important Safety Instructions For Installation And Use 2.
Bracket Installation 3.
Wiring Installation “Quantum™/Classicdrive™” 4.
Wiring Installation “DoorMaster™” 4.
Wiring Installation “idrive™” 5.
Wiring Installation “Torsion idrive™” 5.
Photoelectric Safety Sensor Alignment 6.
Photoelectric Obstruction Sensing Test 6.
Important Safety Instructions 7.
Warranty 7.
Customer Service Number 7.
2
IMPORTANT SAFETY INSTRUCTIONS FOR
INSTALLATION AND USE
DO NOT USE SENSITIVITY
ADJUSTMENT TO COMPENSATE
FOR A POORLY OPERATING DOOR.
THIS WILL INTERFERE WITH THE
PROPER OPERATION OF THE
SAFETY REVERSE MECHANISM.
AFTER INSTALLING OPENER,
THE DOOR MUST REVERSE
WHEN IT CONTACTS A 1 INCH
HIGH SOLID TEST OBJECT ON
THE FLOOR.
DO NOT CONNECT OPENER TO
ELECTRICAL OUTLET UNTIL
INSTRUCTED TO DO SO.
OPEN DOOR MUST NOT CLOSE
AND CLOSING DOOR MUST
OPEN IF PHOTOELECTRIC
SYSTEM IS OBSTRUCTED BY
6”X HIGH OBJECT, USING TEST
PROCEDURE DESCRIBED IN
STEP 4.
INSTALLATION AND WIRING MUST
COMPLY WITH LOCAL BUILDING
AND ELECTRICAL CODES.
CONNECT THE POWER CORD TO A
PROPERLY GROUNDED OUTLET.
DO NOT REMOVE ROUND GROUND
PIN FROM POWER CORD.
DO NOT WEAR RINGS, WATCHES
OR LOOSE CLOTHING WHEN
INSTALLING OR SERVICING A
GARAGE DOOR SYSTEM. USE A
STURDY, NONMETALLIC STEP
LADDER AND WEAR EYE
PROTECTION.
WARNING DISCONNECT ALL POWER FROM GARAGE DOOR OPENER BEFORE SERVICING
OR INSTALLING ACCESSORY PRODUCTS.
THIS IS THE SAFETY ALERT SYMBOL. IT IS USED TO ALERT YOU TO POTENTIAL
PERSONAL INJURY HAZARDS. OBEY ALL SAFETY MESSAGES THAT FOLLOW THIS
SYMBOL TO AVOID POSSIBLE INJURY OR DEATH.
READ AND FOLLOW ALL
INSTALLATION INSTRUCTIONS.