Filter
Top Products
14
Step 9: Installing Deluxe Wireless Wall Station (if included)
WARNING: Install all wall controls out of the reach
of children and in a location where the door can be
seen before activating. Do not mount push buttons
near or next to garage door.
Locate a convenient place to mount wall station. To keep wall station
out of the reach of children, measure at least five feet up from the floor
and secure wall station base into wood wall framing using (2) Phillips
head screws. Pilot drill mounting holes using a 3/32" bit. Use 2 of 3
holes that best align with wood framing.
CAUTION: Over tightening the screws could deform plastic
base and interfere with circuit board snaps.
NOTE: Insert bottom of circuit board behind bottom snap of wall
station base. Pivot circuit board up until board snaps into place.
For best results, press on circuit board between battery terminals.
Insert battery onto circuit board being careful to match (+) positive
battery marking with (+) circuit board marking. Align wall station
cover/button assembly with base. Press cover assembly over base
until cover snaps into place. A uniform seam between the cover and
base indicates a proper installation.
Step 10: Install Entrapment Warning Label
IMPORTANT: Install Entrapment Warning Label
next to wall station in a prominent location
Install Entrapment Warning Label next to Wall Station as
illustrated. If label adhesive will not adhere to the
surface, secure the label by additional mechanical
means such as staples, nails or screws.