Filter
Top Products
15
Setting The Controller - Continued
7. "Set Time" and "12" is now lit. To set the time, press and hold the CHANGE button to
advance the numerical display, and switch from "PM" to "AM" if appropriate. Note: set the
time to the nearest hour. Pressing and releasing the SET button will save the time displayed
and advance to the next menu. Pressing and releasing the SET button will advance pro-
gramming to the next step. Default is 12 PM.
8. "Set Reg. Time" and "02" is now displayed. To set the regeneration time, press and
release the CHANGE button to advance the numerical display. Pressing and releasing the SET
button will save the "regen. time" displayed and put the unit into operation. Default is 2 AM.
PROGRAMMING IS NOW COMPLETE
4 Button Error Descriptions
“E1”
Home magnet not found: Cycle power by unplugging the transformer and plugging it
back in and it will look for Home again.
“E2”
Motor not plugged in: Plug motor in and cycle power. If it is plugged in, then motor
wiring or the motor plug is defective.
“E3”
Home offset error: Disk didn’t start in proper home location. Controller will automatically
try to reset itself by finding Home and continuing the regeneration.
“E4” Magnet stuck at Home: Gear teeth aren’t engaged, gear stripped, something is jammed
in the valve. Cycle the power to reset.
“E5”
Memory error: Replace board.
When calling the HelpLine, please have this guide and the serial number
available. From 8 am to 5 pm EST, call 1-800-437-8993.
Your serial number may be found on top of your valve assembly.