Filter
Top Products
English
8
Preparing the Sprayer
All new units are performance-tested at the factory and are shipped with test uid in the uid section to prevent corrosion
during shipment and storage. If you have already used your pump, some water or solvent used in cleaning may remain
in the uid section. Whether your sprayer is new or if you have already used it, this uid must be purged and thoroughly
cleaned out of the system prior to use. Follow the steps below.
1. Remove oiler cap using a straight-
slot screwdriver. Squirt separating
oil P/N 0516913 supplied with
your sprayer into the oiler
(approximately 1 ounce). Light
household oil can be substituted if
necessary. Replace cap.
2. After lling, push button on front of
face plate 2-5 times to lubricate the
uid section. Press once for every
eight hours of usage. Be sure to
check reservoir level (a) and rell as
necessary.
4. Place a full container of spraying material underneath
the suction tube (a). Secure the return tube (b) into a
waste container.
6. Plug in the sprayer and move the ON/OFF switch to the
ON (l) position.
3. Fully depress the pusher stem to
make sure the inlet ball is free.
5. Turn the pressure control dial to maximum pressure (+).
Turn the PRIME/SPRAY knob to PRIME.
7. Switch the pump OFF (O). Remove the return tube from
the waste container and place it in its operating position
above the container of spraying material. Use the metal
clip to bind the two hoses together.
(a)
(b)
(a)
l
SPRAY
PRIME
The unit will begin to draw material up the suction tube,
into the pump, and out the return tube. Let the unit cycle
long enough to remove test uid from the pump, or until
spray material is coming from the return tube.
9155, 9175 and 9195 only.