Filter
Top Products
English
6
Assembly
Do not plug in the power cord until assembly is complete.
If you have one of the cart models, follow these assembly instructions. If you have the model 9145 sprayer, skip to item 4,
below.
1. Twist the knobs on
either side of the handle
counterclockwise to
unlock the handle. Pull
the handle out fully, and
turn knobs clockwise to
lock into place.
3. Attach the pail bracket. Line up the holes in the bracket
with the holes in the sprayer. Insert and tighten the
screws using a 3/16” allen wrench.
2. Insert the ends of the hose bracket into the holes of the
handle as shown.
4. Thread one end of the high pressure spray hose to
the spray hose port. Hold the port with an adjustable
wrench, and tighten the hose with the other.
5. Thread the other end of the hose to the spray gun. Hold
the gun with one adjustable wrench, and tighten the
hose nut with the other.
6. Thread the suction tube onto the
inlet valve and tighten rmly by
hand. Be sure that the threads
are straight so that the tting
turns freely.
7. Press the return tube onto
the return tube tting.
Squeeze clip over the return
tube tting to secure the
return tube.
8. Verify that the seal is
present inside the suction
tube. Thread the inlet lter
into the end of the suction
tube.
The spray tip should not
be attached until after the
sprayer and spray hose have
been purged and primed.