Filter
Top Products
AFTER SALES SUPPORT 1 888 367 7373 customer-service@wk-usa.com 03-12-14 / VC9385S
Step onto the handle release pedal to put the Carpet Cleaner into cleaning position (Fig. 1).
While depressing the solution release trigger (Fig. 2), pull Carpet Cleaner in a backward
motion. Release the trigger and push the unit forward in the same path to agitate and remove
dirty water and solution from the carpet.
NOTE: For heavier soiled areas repeat if necessary.
Fig. 1
Fig 2
IMPORTANT: For best results use a steady, moderate, forward and backward motion (about 1
second per square foot.) Always work from back to front across the room to avoid stepping on wet
carpet and lowering pile.
When dirty water tank is full, lift water tank latch (Fig. 3) and remove from base using handle.
Twist dirty water tank outlet cap to the left and remove, empty, rinse and replace (Fig. 4).
Fig. 3
Fig. 4
When finished cleaning, remove both dirty and clean water tank and rinse with warm water
and allow to dry before storage.
Remove exhaust filter, rinse with warm water and allow it to dry thoroughly before storing
(Fig.5).
Fig. 5
IMPORTANT: Do not use any chemicals on the carpet when cleaning. ONLY use store bought
carpet cleaner solution. 8