Filter
Top Products
English
7
ADVANCED SAFETY FEATURES
OPERATING TIPS
If unit has been unplugged, start the unit following the start-up
instruction (see How To Use). If unit has not been unplugged, just press
the POWER button and the unit will continue from the last used setting
before it was turned off.
To use your DVTH as a fan set the MODE to FA (fan only).
Your Vornado DVTH, like other 1,500-Watt electric heaters, draws up to
12.5 Amps of electric current. If using your DVTH on HI (high heat)
mode causes your home circuit breaker to fuse or trip, we offer the
following suggestions:
Try turning off other electrical appliances that run on the same circuit
as your heater.
Run your heater on the LO (low heat) mode.
Have your electrician add some additional circuits to your home
electrical system.
When the room temperature is higher than the set temperature it is
normal and correct to have little to no heat coming out of the DVTH.
When the unit is first turned on there is a slight delay before heat will
start to be produced.
ALWAYS USE COMMON SENSE WHEN USING THIS AND/OR
ANY ELECTRICAL APPLIANCE
TIGHT GRILL SPIRALS
Resists curious fingers.
COOL TOUCH CASE
Safe to touch, even on high heat setting.
AUTOMATIC SAFETY SHUT OFF SYSTEM
If airflow becomes blocked, power to the heating
element is shut off to prevent overheating.
TIP-OVER PROTECTION
If tipped over, power to the heating element and fan
motor is reduced to prevent overheating.
IDEAL 120°F EXIT AIR TEMPERATURE
Warm enough to heat an entire room.