Vornado DVTH Electric Heater User Manual


 
English
5
HOW TO USE
Using your Vornado Heater is easy. Just follow these simple steps.
Position your heater so the vortex beam of warm air is directed
across the room unobstructed. Position it in a location that
is representative of the room temperature. The unique side-
angled air inlets allow the heater to be placed closer to walls
than possible with most ordinary heaters (but do not place close
to combustibles). Avoid areas of temperature extremes such
as cold drafts and heat registers. Please refer to IMPORTANT
INSTRUCTIONS at the beginning of this owner’s guide.
Plug the power cord into a standard wall outlet.
Press the POWER button.
Then press the MODE button to select LO (low heat), HI (high
heat), or FA (fan only).
Press the WARMER button to raise the set temperature or
COOLER to lower the set temperature. The unit will display the set
temperature when the SET TEMP light is lit.
Your DVTH will generate only the heat required to obtain and
maintain the set temperature.
CARE & MAINTENANCE
Your heater has no user serviceable parts. Do not disassemble the
unit – it will void your warranty. If service is required, return your
heater to Vornado (see Warranty section).
The motor is permanently lubricated and requires no oiling.
Because your heater moves a substantial amount of air, it will
require regular cleaning. Be sure to unplug the unit prior to any
cleaning activity.
Use a vacuum cleaner with the brush attachment to clean any
accumulated dust on the front grill and the side air inlets. During
the off-season or extended periods of non-use, store your heater.
Unplug the unit and bundle the cord. Save the plastic bag the
heater was shipped in so you can cover the unit and minimize
settling dust.
1.
2.
3.
4.
5.
6.