Filter
Top Products
EN - 12
Attach the dome cover to camera. Secure the dome screws with the supplied screwdriver. Finally,
make sure all parts of the camera are securely installed.
Completion
9
Fine-tune the Camera Focus
The focus of this network camera is set from 1.0m to infinity by factory default. If you want to focus
on objects closer than 1.0m or the lens has lost focus, please fine tune it in the following way.
Tighten the lens lock screw.
1. Loosen the lens lock screw.
2. Manually rotate the lens to fine-tune the focus
until the live image is clear.
3. Tighten the lens lock screw.
Please secure the screws tightly to
prevent the cabling against moisture.
Tear down the aluminum foil vacuum bag and take out the silica gel. Attach the supplied silica gel to
the inner side of the Network Camera. (Please replace the silica gel with a new one if you open the
back cover after installation.)