Filter
Top Products
NO I TULOSESUACME LBORP
sei ret tab ecalpeRr ewop oN
Batteries need to be charged Charge batteries (see Battery Charging)
)s(elbac esool nethgiTe l bac y r e t t ab esooL
Batteries not connected properly Follow battery installation instructions
Brush motor does
not run
rep i V t ca t noChc t iws hsurb daB
Brush circuit breaker has tripped Check brush motor for obstructions and reset breaker
rep i V t ca t noCt uo den r ub sah r e i f i t ceR
r ep i V t ca t noCgn i r i w daB
r ep i V t ca t noCroto m hsurB
r ep i V t ca t noCtuo nrow sehsurb nobraC
r ep i V t ca t noCdionelos daB
Vacuum motor does
not run
r ep i V t ca t noChc t iws muucav
daB
r ep i V t ca t noCgn i r iw daB
r ep i V t ca t noCro t om muucav daB
r ep i V t ca t noCtuo nrow sehsurb nobraC
Short run time
Batteries need to be charged Charge batteries (see Battery Charging)
Batteries need maintenance See Battery Maintenance in this manual
sei ret tab ecalpeR)s(yret tab ni l lec daB
r eg r ahc eca l peRr eg r ahc daB
Little or no solution
flow
r ep i V t ca t noChct iws noi tulos daB
r ep i V t ca t noCdionelos noi tulos deggolC
nae l c dna r e t l i f evomeRr e t l i f no i t u l os deggo lC
Solution line obstructed Remove solution line and clean
Solution flow adjustment knob in need
of adjustment
Increase flow by twisting solution adjustment knob to the
right. Decrease flow by twisting solution adjustment knob
to the left.
Poor water pick up Squeegee clogged Clean debris off squeegee with damp towel
seda l b eegeeuqs wen l l a t sn In r ow seda l b eegeeuqS
Squeegee not mounted correctly
Confirm that the squeegee assembly is securely fastened
to the machine and not loose fitting.
Vacuum hoses have a hole or are loose
Check hose connections and make sure they are firm.
Replace hose if damaged.
Vacuum hose may be clogged Check hose for debris and remove any clog.
.gulp niard nethgiTesool si reppots esoh niarD
Batteries need to be charged Charge batteries (see Battery Charging)
Vacuum motor is loose
Tighten vac motor mounting screws. Do not overtighten or
damage will occur.
Recovery tank lid is loose Confirm the clear recovery tank lid is securely in place.
Recovery tank inlet hole is clogged
Drain recovery tank and tilt tank on side. Check the inlet
hole for debris and remove debris.
. kna t y revoce r n i arDl l u f s i kna t y revoceR
Float shut off is clogged
Remove float shut off from inside recovery tank and
remove any debris.
BASIC TROUBLESHOOTING
is not turing around
20 SCRUBBERS FANG20-EU / FANG20T-EU 82089E(1)2009-04A 82089E(1)2008-11 A
ENGLISH USER MANUAL
Batteries gives no electricity
dealer
Dealer
Dealer
Dealer
Dealer
Dealer
Dealer
Dealer
Dealer
Dealer
Dealer
Dealer