Viper FANG 20-EU Vacuum Cleaner User Manual


 
USER MANUAL
ENGLISH
MACHINE
ST
ART
AND
STOP
1. Set control housing to a comfortable operating height by squeezing together the two thumb
levers directly underneath the housing. (see machine components, item #10)
2. Lower squeegee assembly to the floor by releasing the lift lever from its locked position.(see machine components, item #13)
3. Lower brush head assembly to the floor by stepping on the foot pedal and pushing pedal forward. (see machine components,
item #8)
4. Turn main power to “on” position.(see machine components,item#24)
5. Turn brush motor to “on” position. (see machine components, item #2)
6. Turn vacuum motor switch to “on” position.(see machine components, item #1)
7. Turn the solution switch to “on” position. (seemachine components, item #4)
a. Solution will not begin to flow until the operating triggers are pulled.
8. The Fang 20T-EU is self-propelled.The speed can be controlled by a dial located on the right side of the control housing.(see
machine components,item #26)
9. The Fang 20T-EU has reverse.In order to activate reverse,there is a toggle switch located on the left side of the control housing.(see
machine components,item #25)
10. To begin scrubbing, pull on one or both of the red operating triggers. (see machine components, item #23) When these triggers
are pulled, the brush will begin to spin and the solution will begin to flow.The Fang 20T-EU will propel itself.
11. The Fang 20-EU Begin scrubbing by moving the machine forward. : Do not keep the machine in the same position with the pad /
brush spinning, or you could cause damage to the floor.
12. Adjust amount of solution flow by turning the solution control knob. Turn to the right for more solution, or turn left for less
solution. (see machine components, item #5)
WARNING!
Do not operate machine unless you have read and understand this manual.
WARNING!
Do not keep the machine in the same position with the pad / brush spinning, or you could cause damage
to the floor.
NOTE
For correct scrubbing/drying of oors at the sides of the walls, Alto suggests to go near the walls with the right side of
the machine as shown .
A
B
CAUTION!
To avoid any damage to the fl oor surface, turn off the brush/pad-holder when the machine stops in one
place, especially when the extra pressure function is on.
82089E(1)2009-04A SCRUBBERS FANG20-EU / FANG20T-EU 13