Filter
Top Products
7
Assembly Instructions
1. Set the lamp base on the floor and insert
the lamp shaft over the base support unit
until the screw holes line up as shown in
Fig. 1. Insert the screw using the tightening
tool and turn clockwise to tighten.
2. Hold the upper shaft with one hand
and release the ergonomic height
adjustment lever by gently pulling it
upward as shown in Fig. 2. Extend
the upper shaft approximately
12". Lock the adjustment lever by
gently pushing it downward. Once
assembly instructions are complete,
raise or lower the upper shaft to
the desired height by releasing and
locking the height adjustment lever.
Close-up of screw hole in
the lamp base
Fig. 1
Fig. 2