Filter
Top Products
8
Troubleshooting
Before requesting service on your Verilux
®
lamp, please read the
following:
•Makesureallpowerconnectors,cordsandplugsareinsertedfully
and securely.
• Besurethebulbissecurelyseatedintothesocket(seepage9).
• Makesurethereispowertothewalloutletortryanotheroutlet.
• DISCONNECTLAMPBEFOREPERFORMING
ALIGNMENT ACTIVITY. MISE EN GARDE : DÉBRANCHERLA
LAMPEAVANTD’EFFECTUERSONALIGNEMENT.
Correct alignment with screw holes can be accomplished by following
these steps:
1. Always start with the base and work your way up the shaft and
attach the head last.
2. Placeyourfootonthebaseofthelamponthefloor.
3. While holding the shaft with your hand, gently rock the unit back
and forth.
4. Shaft should ease into socket and screw holes will align.
PROBLEM CHECK SOLUTION
Light Won’t
Come On
Blackening/Darkening
at Ends of Bulb
Light Flickers
Has the plug come
loose?
Is the bulb old?
Is the bulb connected
securely into socket?
Is the bulb new?
Is the bulb old?
Has the plug come
loose?
Is the bulb connected
securely to the socket?
Is the lamp connected
to a dimmer switch?
Insert plug securely into wall outlet.
Check bulb for blackening/darkening at bottom of spiral where it joins the
base (an indicator of bulb life) and replace bulb.
Be sure the bulb is securely seated into socket, repeat the bulb
installation process.
Sometimes when a new bulb is turned on for the first time the tube will
darken, but this will fade after a few minutes.
With older bulbs, darkening of the tube indicates end of bulb life (this
doesn’t affect operation except to reduce the amount of light available
since the phosphor in that area has become inactive). Bulb replacement
is recommended.
Insert plug securely into wall outlet.
Connect lamp plug only to wall outlet without dimmer switch.
Be sure the bulb is securely seated into the socket, repeat the bulb
installation process. ALWAYS UNPLUG LAMP BEFORE
PERFORMING BULB REPLACEMENT OR INSTALLATION.
CAUTION:
CAUTION: