Vanguard Heating VMH3000TPA Electric Heater User Manual


 
10
107098
PROPANE/LP GAS RESIDENTIAL HEATERS
®
For more information, visit www.desatech.com
Attaching To Wall Anchor Method
For attaching mounting bracket to hollow
walls (wall areas between studs) or solid
walls (concrete or masonry)
1. Drill holes at marked locations using
5/16" drill bit. For solid walls (concrete
or masonry), drill at least 1" deep.
2. Fold wall anchor as shown in Figure 12.
3. Insert wall anchor (wings first) into
hole. Tap anchor flush to wall.
4. For thin walls (1/2" or less), insert red
key into wall anchor. Push red key to
“pop” open anchor wings.
IMPORTANT:
Do not hammer key!
For thick walls (over 1/2" thick) or solid
walls, do not pop open wings.
5. Place mounting bracket onto wall. Line
up last hole on each end of bracket with
wall anchors.
6. Insert mounting screws through bracket
and into wall anchors.
7. Tighten screws until mounting bracket
is firmly fastened to wall.
INSTALLATION
Continued
Figure 14 - Mounting Heater Onto Mount-
ing Bracket
Installing Bottom Mounting
Screws
1. Locate two bottom mounting holes.
These holes are near bottom on back
panel of heater (see Figure 15).
2. Mark screw locations on wall.
3. Remove heater from mounting bracket.
4. If installing bottom mounting screws
into hollow or solid wall, install wall
anchors. Follow steps 1 through 4 un-
der Attaching To Wall Anchor Method.
If installing bottom mounting screw
into wall stud, drill holes at marked lo-
cations using 9/64" drill bit.
5. Replace heater onto mounting bracket.
6. Place spacers between bottom mount-
ing holes and wall anchor or drilled hole.
7. Hold spacer in place with one hand.
With other hand, insert mounting screw
through bottom mounting hole and
spacer. Place tip of screw in opening
of wall anchor or drilled hole.
8. Tighten both screws until heater is firmly
secured to wall. Do not over tighten.
Note:
Do not replace front panel at this
time. Replace front panel after making
gas connections and checking for leaks
(see pages 12 and 13).
Figure 15 - Installing Bottom Mounting
Screws
B. MOUNTING HEATER ON
OPTIONAL HEARTH BASE
Tools needed:
#2 Phillips screwdriver
slotted screwdriver
electric drill (if securing base to floor)
The optional hearth base kit includes the
following:
Hearth Base
4 Wood Screws
4 Sheet Metal Screws
Brass Base Trim
Hearth Insert
4 Anchors
2 Brass Screws
Note:
It is an option to secure “A” model
hearth base to floor. You must secure the
“B” and “C” model hearth base to floor. To
secure hearth base to floor, follow instruc-
tions under Securing Hearth Base to Floor,
page 11. If not securing hearth base to floor,
proceed to Mounting Heater to Optional
Hearth Base, page 11.
Figure 12 - Folding Anchor
Figure 13 - Popping Open Anchor Wings
For Thin Walls
Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on back
panel of heater.
2. Place heater onto mounting bracket.
Slide horizontal slots onto stand-out
tabs on mounting bracket.
Horizontal Slots
Mounting Bracket
(attached to wall)
Stand-Out
Tab