Filter
Top Products
13
103448
Gas Control
Flexible Gas Hose (if
allowed by local codes)
INSTALLING
Continued
Installation Items Needed
• hardware package (provided with heater)
• approved flexible gas hose (not provided) (if allowed by local codes)
• sealant (resistant to propane (LP) gas, not provided)
• electric drill with 3/16" drill bit
Note:
Install optional GHRCT Receiver and Hand Held Remote Control Kit (see Accessories, page 30)
before installing gas log heater. See installation instructions included with the kit.
1. Apply pipe joint sealant lightly to male threads of gas fitting. Connect approved flexible gas hose to
inlet side of gas control (see Figure 10).
2. Position heater base assembly in fireplace.
3. Mark screw locations through holes in front panel of base (see Figure 11). If installing in a brick-
bottom fireplace, mark screw locations in mortar joint of bricks.
4. Remove heater base from fireplace.
5. Drill holes at marked locations using 3/16" masonary drill bit.
6. Attach base to fireplace floor using masonry screws (in hardware package).
7. Connect to gas supply. See Connecting To Gas Supply, page 14.
Figure 10 - Attaching Flexible Gas Hose to Heater Gas Regulator
Continued
Figure 11 - Attaching Base to Fireplace Floor
Masonry Screw
Masonry Screw