Filter
Top Products
12
103448
14"
Min.
Combustible
Material
Non-Combustible
Material
Hearth
5"
Min.
Combustible
Material
INSTALLING
Continued
Floor Clearances
A. If installing appliance on the floor level, you must maintain the minimum distance of 14" to combus-
tibles (see Figure 8).
Figure 8 - Minimum Fireplace Clearances If Installed at Floor Level
B. If combustible materials are less than 14" to the fireplace, you must install appliance at least 5" above
the combustible flooring (see Figure 9).
Figure 9 - Minimum Fireplace Clearances Above Combustible Flooring
INSTALLING HEATER BASE ASSEMBLY
WARNING
You must secure this heater to fireplace floor. If not, heater will move when you adjust
controls. Moving heater may cause a gas leak.
WARNING
If installing in a sunken fireplace, special care is needed. You must raise the fireplace floor
to allow access to heater control panel. This will insure adequate air flow and guard against
sooting. Raise fireplace floor with non-combustible material. Make sure material is secure.
CAUTION
Do not pick up heater base assembly by burners. This could damage heater. Only handle
base assembly by grates.
IMPORTANT:
Make sure the heater burners are level. If heater is not level, heater will not work properly.