Filter
Top Products
19
6. Push in the control (knob 1) all the way and
rotate counter-clockwise to "PILOT".
The piezo ignitor will light the pilot as the knob
passes "IGN" traveling to the "PILOT". Con
tinue to hold the control (knob 1) in for about
ten (10) seconds after the pilot is lit. Release
knob and it should pop back up. Pilot should
remain lit. If it goes out, repeat steps 4 through
6. If the control (knob 1) does not pop up when
released, stop and immediately call your ser
vice technician or gas supplier. If the pilot will
not stay lit after several tries, turn the gas
control (knob 1) to "OFF" and call your service
technician or your gas supplier.
7. Turn gas control (knob1) counter-clockwise
to "ON".
8. Set the burner (knob 2) to the desired setting
rotating counter-clockwise to MAX. and
clockwise to MIN.
9. Close access door and turn on electrical power.
OPERATING INSTRUCTIONS
LIGHTING INSTRUCTIONS
1. Open access door.
2. Set burner to Min. by rotating knob clockwise until stop.
3. Unplug all electric power if service is to be performed.
4. Push in gas control knob slightly and turn clockwise to "OFF". Do not force.
5. Close access door.
TURN OFF GAS TO APPLIANCE
1. STOP! Read the safety information on the
previous page.
2. Turn off all electrical power and open the
access door.
3. Turn off the rear burner and set the front
burner to low.
4. Push in gas control (knob 1) slightly and turn
clockwise to "OFF".
NOTE: Knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not
force.
5. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor. If
you smell gas, STOP! Follow "B" in the safety
information on the previous page. If you don't
smell gas, go on to the next step.
PILOT LOCATION
TOP VIEW OF BURNER ASSEMBLY