Filter
Top Products
LOG POSITIONING
Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from
ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any
traces of fibers.
PROPER INSTALLATION SEQUENCE:
LOG ASSEMBLY
The positioning of the logs is critical to the safe and clean operation of this
heater. Sooting and other problems may result if the logs are not properly
and firmly situated in the appliance. Never add additional logs or
embellishments such as pine cones, vermiculite or rock wool to the heater.
REMOVING FRONT SCREEN: 1) Remove screw from the top of the screen (Fig. 8A). 2) Tilt the top of
the screen toward you slightly and lift the screen up out of the screen retainer (Fig. 8B). NOTE: To reinstall
the front screen, reverse steps 1 & 2.
FIG. 8A FIG. 8B
REMOVING FRONT SCREEN
FIGURE 9. Log Set Assembly
WARNING: Failure to position the
parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
WARNING
11