Filter
Top Products
1) Remove the two(2) screws and lift the front screen slightly up. (Fig. 7A) Then tilt the bottom of the screen
inward and downward. (Fig. 7B) 2) Lean the top of the screen toward you slightly (Fig. 7B) and then
proceed to carefully bring the screen straight back (Fig. 7C). NOTE: To reinstall the front screen, reverse
steps 1 & 2.
11
REMOVING FRONT SCREEN
WARNING
The positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly
situated in the appliance. Never add additional logs or embellishments such as
pine cones, vermiculite or rock wool to the heater.
LOG POSITIONING
Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:
LOG ASSEMBLY
FIG 7CFIG 7B
FIG 7A
FIGURE 8. Log Set Assembly
WARNING: Failure to position the
parts in accordance with these dia-
grams or failure to use only parts
specifically approved with this heater
may result in property damage or
personal injury.