Filter
Top Products
USSC 11
Do not operate your stove with the viewing door open. The auger will not feed pellets under these
circumstances and a safety concern may arise from sparks or fumes entering the room.
This heater is designed and approved for premium hardwood pellet fuel only. Any other type of fuel burned
in this heater will void the warranty and safety listing.
A working smoke detector must be installed in the same room as this product.
HOW YOUR STOVE WORKS
Your King/Ashley stove utilizes a inclined auger fuel feed system that is operated by a microprocessor controlled digital
circuit board. The digital circuit board allows the inclined auger fuel feed system to run in a timer-based, non-continuous
cycle; this cycling allows the auger to run for a predetermined period of seconds. The auger pushes pellets up a chute
located at the front/bottom of the hopper which in turn falls through another chute into the burnpot . As pellets enter the
burn pot, outside air is drawn across the fuel and heated during the combustion process. This heated combustion air is
then pulled through the heat exchanger by the Exhaust Motor, where it is used to heat air that is drawn into the heat
exchanger system by the distribution blower.
Because a forced draft pressure is required for the combustion process inside your stove, it is extremely important that
the exhaust system be properly installed and maintained. And, that when operating your stove, you make sure that the
viewing door is properly sealed.
Your stove’s heat output can vary from hi to low by adjusting the settings on the control panel (located on the lower right-
hand side of the stove). The “HEAT RANGE” setting will vary the auger systems feed rate and the exhaust blower
speed (i.e. combustion air). The “BLOWER SPEED” setting will adjust the dstribution blowerr sped (i.e. convection
air). Each setting has a range of 1 to 9 (lowest to highest). Any combination of “HEAT RANGE” and “BLOWER
SPEED” can be used during the operation of your stove.
Your stove can run efficiently over extended periods of time and at different heat output levels as long as the fuel supply
is uninterrupted and proper cleaning and maintenance is performed. (NOTE: Operating your stove on a high “HEAT
RANGE” setting and a low “BLOWER SPEED” setting for extended periods of time may cause your stove to reach an
over-temperature condition, in which case, the stove will automatically reduce the fuel feed rate and/or increase the
distribution blower speed. This is a safety precaution that has been designed into your stove and is not a malfunction)
Operation
ÌÌ
ÌÌ
Ì
ÌÌ
ÌÌ
Ì
ÌÌ
ÌÌ
Ì