Filter
Top Products
Ussc 5
Tools and Materials Needed For Installation
You will need a drill with a 1/8” bit to install sheet metal screws into connector pipe. A 5/16” socket/wrench or screw driver
to install pedestal trim, room air deector, and blower assembly described below. A 1/2” socket/wrench to install ue
collar. A non-combustible oor protector as specied in this manual. All chimney and chimney connector components
required for your particular chimney installation.
Assembly
Flue Collar Assembly:
1. Mount the ue collar to the top of the unit as shown using the (3)
5/16-18 x 1-1/2 bolts, (3) washers, and (3) weld
tabs
provided in the parts box.
Room Air Deector Assembly:
1. Locate the Room Air Deector. Using the three(3) 1/2 Tek Screws provided, mount the deector to the unit as
shown in the diagram.
Firebrick Conguration:
1. Replace the Firebrick as shown in the illustration below.
Side view of ue collar
mount to heater top
Brick Conguration
HEATER
TOP
WELD
TAB
5/16-18 x 1-1/2
BOLT