Filter
Top Products
Ussc 17
THE FIRST FIRES
The fresh paint on your stove needs to be cured to preserve its quality. Once the fuel charge is properly ignited, only
burn small res in your stove for the rst four hours of operation. Never open the air control more than necessary to
achieve a medium burn rate.
Make sure that there’s enough air circulation while curing the stove. The odors could be smelled during the 3 or 4 rst
res. Never start your stove outside. You will not be able to see if you are over heating.
Do not build res too close to the glass. Try building behind the lip just inside the door opening.
IGNITION
After making sure that the stove air intake controls are fully open (completely pull-out towards you), place several rumpled
sheets of paper in the centre of the combustion chamber. Place 8 to 10 pieces of small dry kindling wood over the paper
in the form of a tent. You may also place a few pieces of heating wood, but choose the smaller ones. No chemical product
should be used to light the re.
Before igniting the paper and kindling wood, it is recommended that you warm up the chimney. This is done in order to
avoid back draft problems often due to negative pressure in the house. If such is the case, open a window slightly near
the stove and twist together a few sheets of newspaper into a torch. Light up this paper torch and hold it as close as
possible to the mouth of the pipe inside the combustion chamber to warm up the chimney. Once the updraft movement
is initiated, you are ready to ignite the stove by lighting the paper and kindling wood inside the combustion chamber.
When you have achieved a good bed of hot embers, we recommend the following burn procedures:
HEATING
Controlled combustion is the most efcient technique for wood heating because it enables you to select the type of
combustion you want for each given situation. The wood will burn slowly if the wood stove air intake control is adjusted
to reduce the oxygen supply in the combustion chamber to a minimum. On the other hand, wood will burn quickly if
the air control is adjusted to admit a larger quantity of oxygen in the combustion chamber. The air intake control on
your stove is very simple. If you pull on it out completely towards you, it is fully open. If you push on it until it stops the
combustion air is reduced to a minimum. Real operating conditions may give very different results than those obtained
during testing according to the species of wood used, its moisture content, the size and density of the pieces, the length
of the chimney, altitude and outside temperature.
CAUTION: Never alter the damper slide or the adjustment range to increase ring for any reason. Doing so could
result in heater damage and will void your warranty.
3000
Primary Air Settings
(Slide Damper is located in center of stove under hearth plate)
(Damper Adjustment: Pulling out on damper increases air)
Electric Blower Speed Setting (Variable)
(Blower is on High when turned “ON”, Rotate clock-
wise until stop for “LOW”.)
Burn Rate Adjust Damper from fully closed Burn Time Blower Speed
Low 1/8” (3.2mm) @ 30 minutes Low
Medium - Low 1/4” (6.3mm) @ 30 minutes Low
Medium - High 1-1/8” (12.7mm) @ 30 minutes Low
High approx. 3” (76mm) all minutes High