Filter
Top Products
LOG ASSEMBLY
LOG POSITIONINGLOG POSITIONING
LOG POSITIONINGLOG POSITIONING
LOG POSITIONING
This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs with your
bare hands! Always wear gloves to prevent skin irritation from ceramic fibers. After handling
logs, wash your hands gently with soap and water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:PROPER INSTALLATION SEQUENCE:
PROPER INSTALLATION SEQUENCE:PROPER INSTALLATION SEQUENCE:
PROPER INSTALLATION SEQUENCE:
1. Install the rear log (#2) on the rear set of locators. Visually check to verify the log is securely
placed on the locators.
2. Install the front log (#1) on the front locators. Visually check to verify the log is securely
placed on the locators.
3. Place the cross logs on the locator studs in the log as shown. The flame should not touch
the cross logs otherwise suiting will occur.
WARNING: Failure to position theWARNING: Failure to position the
WARNING: Failure to position theWARNING: Failure to position the
WARNING: Failure to position the
parts in accordance with theseparts in accordance with these
parts in accordance with theseparts in accordance with these
parts in accordance with these
diagrams or failure to use onlydiagrams or failure to use only
diagrams or failure to use onlydiagrams or failure to use only
diagrams or failure to use only
parts specifically approved withparts specifically approved with
parts specifically approved withparts specifically approved with
parts specifically approved with
this heater may result in propertythis heater may result in property
this heater may result in propertythis heater may result in property
this heater may result in property
damage or personal injury.damage or personal injury.
damage or personal injury.damage or personal injury.
damage or personal injury.
WW
WW
W
ARNINGARNING
ARNINGARNING
ARNING
The positioning of the logs is critical to the safe and cleanThe positioning of the logs is critical to the safe and clean
The positioning of the logs is critical to the safe and cleanThe positioning of the logs is critical to the safe and clean
The positioning of the logs is critical to the safe and clean
operation of this heateroperation of this heater
operation of this heateroperation of this heater
operation of this heater
..
..
.
Sooting and other pr Sooting and other pr
Sooting and other pr Sooting and other pr
Sooting and other pr
obob
obob
ob
lems malems ma
lems malems ma
lems ma
y result ify result if
y result ify result if
y result if
the logs are not properly and firmly situated in the appliance.the logs are not properly and firmly situated in the appliance.
the logs are not properly and firmly situated in the appliance.the logs are not properly and firmly situated in the appliance.
the logs are not properly and firmly situated in the appliance.
Never add additional logs or embellishments such as pine cones,Never add additional logs or embellishments such as pine cones,
Never add additional logs or embellishments such as pine cones,Never add additional logs or embellishments such as pine cones,
Never add additional logs or embellishments such as pine cones,
vermiculite or rvermiculite or r
vermiculite or rvermiculite or r
vermiculite or r
ococ
ococ
oc
k wk w
k wk w
k w
ool to the heaterool to the heater
ool to the heaterool to the heater
ool to the heater
..
..
.
FIGURE 8 - Log Set AssemblyFIGURE 8 - Log Set Assembly
FIGURE 8 - Log Set AssemblyFIGURE 8 - Log Set Assembly
FIGURE 8 - Log Set Assembly
14
#2
#1