Filter
Top Products
8 ■English
Preparation Before Operation
■ To operate the remote controller
• To use the remote controller, aim the transmitter at the indoor unit.
If there is anything to block signals between the unit and the
remote controller, such as a curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is about 23 Ft..
■ To fix the remote controller holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, or similar location with
the screws procured locally.
3. Place the remote controller in the remote controller
holder.
ATTENTION
■
■■
■ About remote controller
• Do not put the remote controller in the following places.
• In direct sunlight.
• In vicinity of a heater.
•
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room. Consult your authorized dealer if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to
somewhere else, or consult your authorized dealer.
Receiver
Remote controller
holder
Set.
●
To remove, pull it upwards.
01_EN_3P141693-2C (A4).fm Page 8 Saturday, September 25, 2004 11:39 AM