Toshiba RAV-SP564ATZG-E Air Conditioner User Manual


 
– 149 –
Screws
Front cabinet
Inverter cover
Cord clamp
Screws
(Discharging
period
10 seconds
or more)
Plug of
soldering iron
Discharging
position
Inverter
assembly
Remove the connectors
with locking function by
pushing the part indicated
by the arrow mark.
No.
3
Part name
Inverter
assembly
Procedure
1. Detachment
1) Perform work of item 1 of
1
.
2) Take off screws of the upper part of the front
cabinet.
If removing the inverter cover under this
condition, P.C. board can be checked.
If there is no space in the upper part of the
upper cabinet, perform work of
2
.
CAUTION
Be careful to check the inverter because high-
voltage circuit is incorporated in it.
3) Perform discharging by connecting
+
,
polarities by discharging resistance (approx.
100, 40W) or plug of soldering iron to
+
,
terminals of the C14 (printed as “CAU-
TION HIGH VOLTAGE”) electrolytic capaci-
tor (500µF) of P.C. board.
WARNING
The electrolytic capacitor may not normally
discharge according to error contents and the
voltage may remain. Therefore, be sure to
discharge the capacitor.
WARNING
For discharging, never use a screwdriver and
others for short-circuiting between
+
and
electrodes. As the electrolytic capacitor is one
with a large capacity, it is very dangerous
because a large electric spark will occur.
4) Take off screws (ST1T Ø4 × 8L, 2 pcs.)
fixing the main body and the inverter box.
5) Remove various lead wires from the holder
at upper part of the inverter box and wiring
holder at right side of the terminal block.
6) Remove the lead wire from the bundled part
at left side of the terminal block.
7) Pull the inverter box upward.
8) Disconnect connectors of various lead
wires.
REQUIREMENT
As each connector has a lock mechanism,
avoid to remove the connector by holding the
lead wire, but by holding the connector.
Remarks