Filter
Top Products
–24–
Under Ceiling Type
Installation Manual
EN
Toshiba
Procedure 1
Push simultaneously + + buttons for 4
seconds or more. After a while, the display part flashes
as shown below. Check the displayed CODE No. is
[10].
• When the CODE No. is other than [10], push
button to erase the display and repeat procedure
from the first step.
(After pushing
button, operation of the remote
control is not accepted for approx. 1 minute.)
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
Procedure 2
Every pushing button, the indoor UNIT No. in
the group control is displayed in order. Select the
indoor unit of which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be confirmed because fan and
louver of the selected indoor unit operate.
Procedure 3
1. Using temp. setup / buttons, specify CODE
No. [12].
(CODE No. [12]: Line address)
2. Using timer time / buttons, change the line
address from [3] to [2].
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Procedure 4
1. Using temp. setup / buttons, specify CODE
No. [13].
(CODE No. [13]: Indoor address)
2. Using timer time / buttons, change the indoor
address from [3] to [2].
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Procedure 5
1. Using temp. setup / buttons, specify CODE
No. [14].
(CODE No. [14]: Group address)
2. Using timer time / buttons, change the setup
data from [0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit:
0002])
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
2,61
7
3
-1,
4
-1,
5
-1,
7
3
-3,
4
-3,
3
-2,
4
-2,
5
-2
5
-3,
(* Display changes according to
the model No. of indoor unit.)
Indoor UNIT No. before setup change is displayed.
Indoor UNIT No. before setup change is displayed.
Indoor UNIT No. before setup change is displayed.
24-EN
+00EH99864801_00Ta.book Page 24 Tuesday, November 24, 2009 5:40 PM