Filter
Top Products
– 113 –
No.
3
Part name
Discharge
port cabinet
Procedure
1. Detachment
1) Carry out the operation in 1. of
Q
and 1. of
R
above.
2) Remove the screws fixing the inverter assembly,
the discharge port cabinet and the partition board.
(ST1T Ø4 × 8, 4 pcs.)
3) Remove the screws for the discharge port cabinet
and the bottom plate.
(Hexagonal screw Ø4 × 10, 2 pcs.)
4) Remove screw for the discharge port cabinet and
heat exchanger. (ST1T Ø4 × 8, 1 pc.)
5) Remove screw for the discharge port cabinet and
the motor base. (ST1T Ø4 × 8, 2 pcs.)
6) Remove screws for the discharge port cabinet
and the fin guard.
(Hexagonal screw Ø4 × 10, 2 pcs.)
2. Attachment
1) Place upper left side of discharge cabinet in cut
on upper side of end board of heat exchanger and
fix with a screw. (ST1T Ø4 × 8, 1 pc.)
2) Mount other removed screws into original
positions.
Remarks
Heat exchanger
Motor base
Inverter assembly
Discharge
Discharge
port cabinet
port cabinet
Discharge
port cabinet
Bottom plateFin guard
Cut in end plate
of heat exchanger
Discharge
port cabinet