Toshiba RAS-10GAVP-E Air Conditioner User Manual


 
50
10-3. Indoor Unit
10-3-1. Installation Place
A place which provides enough spaces around the
indoor unit as shown in the diagram.
A place where there are no obstacle near the air
inlet and outlet.
A place which allows easy installation of the piping
to the outdoor unit.
A place which allows the front panel to be opened.
The indoor unit shall be installed so that the top of
the indoor unit is positioned at least 2m in height.
Also, avoid putting anything on the top of the
indoor unit.
CAUTION
Direct sunlight on the indoor unit wireless
receiver should be avoided.
The microprocessor in the indoor unit should
not be too close to r-f sources.
(For details, see the owner's manual.)
Remote controller
Should be placed where there are no obstacles,
such as curtains, that may block the signal.
Do not install the remote controller in a place
exposed to direct sunlight or close to a heating
source, such as a stove.
Keep the remote controller at least 1 m away from
the nearest TV set or stereo equipment.
(This is necessary to prevent image disturbances or
noise interference.)
The location of the remote controller should be
determined as shown below.
Fig. 10-3-1
10-3-2. Drilling a Hole and Mounting Instal-
lation Plate
Drilling a hole
When install the refrigerant pipes from the rear.
Fig. 10-3-2
1. After determining the pipe hole position on the
installation plate (
ð
) drill the pipe hole (Ø65
mm) at a slight downward slant to the outdoor
side.
NOTE :
When drilling into a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
Mounting the installation plate
Indoor unit
(Top view)
(Side view)
Remote
controller
Remote controller
Indoor unit
*: Axial distance
Reception
range
Reception
range
42 mm
65 mm
The center of the
pipe hole
Pipe
hole
Fig. 10-3-3
91 mm
25 mm
Anchor bolt holes
Pipe hole
Pipe hole
Indoor unit
7 Mounting screw
1 Installation plate