Filter
Top Products
Paths – 1
234
Valve Box
Maximum communication wire length
between the controller and the farthest
decoder is 15,000ft (4500m).
Recommended Cable for Controller-to-Decoder is the Paige
®
P7350D, 14 AWG, Solid Copper, Jacketed 2-Conductor,
Direct Burial cable.
White
Black
White
Black
White
Black
White
Black
The maximum communication wire length
between the decoder module and the
solenoid is 410ft (125m).
Recommended Cable for Decoder-to-Solenoid
is the Paige
®
P7351D, 14 AWG, Solid Copper,
2-Conductor, Direct Burial cable.
To easily identify stations for
troubleshooting, install wires with the same
color code as the station wires.
Output Board
White Power/Communication Wire
Black Power/Communication Wire
Station 1
Solid Red Station Wire - Connect to the Red/White solenoid wire
Red with Black Stripe
Station Wire - Connect to the Black solenoid wire
Station 2
Solid Green Station Wire - Connect to the Red/White solenoid wire
Green with Black Stripe
Station Wire - Connect to the Black solenoid wire
Station 3
Solid Orange Station Wire - Connect to the Red/White solenoid wire
Orange with Black Stripe
Station Wire - Connect to the Black solenoid wire
Station 4
Solid Blue Station Wire - Connect to the Red/White solenoid wire
Blue with Black Stripe
Station Wire - Connect to the Black solenoid wire
Figure 4
Each station can activate up
to two DC Latching Solenoids.
Out to additional
decoder modules
Station Wires
The Stand-Alone TDC output board
can accommodate up to 100 stations.
The decoder modules can be
connected in any configuration using
the four station terminals.
1-Station
Decoder
Module
When possible, install the decoder
module in a valve box for ease of service.
DC Latching
Solenoid
Red
Black