Filter
Top Products
Page 8
Figure 7. LLG Connection/Schematic Wiring Diagram
be wired for remote operation. The CS-02 remote
control permits switching from one temperature
controller to the other and turning the heater on and
off from a remote location. The CS-04 includes the
same features as the CS-02 plus a remote tempera-
ture controller. Contact Teledyne Laars for further
information. Reference part numbers CS-02 and
CS-04.
An interrupt (on/off) type remote can be
connected by removing the jumper wire on the terminal
block located in the control compartment (see
Figure 6) and connecting the two wires from the
remote to the two terminals on the terminal block. This
type of remote control will turn the heater on or off,
but will not switch between the two temperature
controllers on the Flex-Temp control panel.