Filter
Top Products
10
Exiting Program Mode
You may exit Program Mode at any time. To exit and save your selections,
press and holdthe Program button for three seconds. A special tone
sounds with four rapid flashes from the left LED light .
If no signal is received from the remote control for 20 seconds, the alarm
unit will automatically exit Program Mode. Any changes made before
exiting Program Mode will be saved.
Alarm Unit Low Battery Warning
Your DEFCON 3 Security System warns you when it detects a low battery
condition. Upon arming or disarming your alarm unit, you will hear an
extended low tone in addition to the usual one or two beeps. When you
hear this tone, replace the batteries as soon as possible.
If this occurs while you are traveling, don't worry - the DEFCON 3
Security System is designed to offer several more days of service beyond
the initial warning. Please dispose of used batteries safely.
Alarm Unit Tips
Remember to secure the battery cover screw to prevent tampering with
your DEFCON 3.
To conserve battery power while the DEFCON 3 Security System is not in
use, turn the end of the cable counterclockwise until the alarm unit beeps
three times. After approximately 30 seconds, the alarm will no longer
respond to signals from the remote control. During those 30 seconds,
however, the alarm will sound if any button on the remote control is
pressed. If this happens, press and hold any button on the remote control
to deactivate the alarm siren.
For best results, replace alarm unit batteries every 90 days. Never combine
old and new batteries.
Whenever you insert or replace the batteries in the alarm unit, the LED
lights will flash alternately to indicate that the alarm unit is waiting for a
signal from the remote control. You must press and holdeither button on
the remote control until the alarm beeps six times and the LED lights stop
flashing.
Caution: For security reasons, some airlines may require that you
remove this kind of device from your luggage or personal carry-on
items. We recommend that you detach the cable from the alarm unit by
unscrewing it prior to checking in at the airport.