Filter
Top Products
22
Front view
left view
Side view showing control operation
Adjustable Air Deflector
Move up or down to
adjust air direction
Adjustable Door Handle
lifts up and turns to the left
to open
Sliding heat exchanger tube cleaning
rod
. Pull in and out to clean heat
exchanger tubes.
Adjustable hinges. Loosen locking
nut and move in or out to adjust.
Ash Pan (3502 models only)
Pedestal Ash Pan (3500P & 3500L
models)
Pull out to empty ash pan. Make sure
that the ash pan is up against the seal
on the pedestal when in place.
Ash clean outs (3500P & 3500L
model) Pull out to empty ashes
out of firebox area and back heat
exchanger area. Make sure to
push all the way in when done.
Left Side
Circuit Board control panel.
Open door and select heat and
fuel stirrer settings.
Manual Draft Adjustment
control knob.
Slide in or out to
decrease or increase draft
Adjustable Air Deflector
Slide Heat Exchanger Tube cleaning
rod in and out to clean tubes
shown pulled out
Ash Cleanouts located on the left
and right side of the front of unit.
Slide out for cleaning. (3500P &
3500L models)
shown pulled out
STOVE CONTROLS
There is a scraper provided with the
unit for cleaning out the ash. There is
a hole in one end for hooking onto the
front heat exchanger tube rod for
cleaning if the unit is hot.
If you want to, you can purchase an
adhesive back hook and place it on
the back panel of the unit to store the
scraper tool. This can be purchased
at any local hardware store.