Filter
Top Products
24
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
*All compressed flex vents can be expanded up to two times.
detsiL xelFeruceS stnenopmoC™
.taC
.oN
ledoM
.oN
noitpircseD
.retpadaxelfdnaspmalcraeg,recaps/potserifedulcnistiknoitanimretesehT
49L68RTH-FSnoitanimreTdnuoRlatnoziroH
xelFtuohtiw
28L77R21TIKFS.ni21htiw.mreTdnuoRxelF
xelFdesserpmoc*fo)mm503(
38L77R81TIKFS.ni81htiw.mreTdnuoRxelF
xelFdesserpmoc*fo)mm754(
48L77R42TIKFS.ni42htiw.mreTdnuoRxelF
xelFdesserpmoc*fo)mm016(
58L77R63TIKFS.ni63htiw.mreTdnuoRxelF
xelFdesserpmoc*)mm419(
68L77R84TIKFS.ni84htiw.mreTdnuoRxelF
xelFdesserpmoc*fo)mm9121(
10L78KRHFSxelFhtiwtiKresiRlekronS
dna,xelFfonoitcesa,retpadA
spmalCraeG
04M91FH5.4FS-recapS/potseriF
)gnicaps1-1-3(latnoziroH
14M91FB5.4FS-recapS/potseriF
)gnicaps1-1-1(lacitreV
12 (305) MANTEL
10 (254) MANTEL
8 (203) MANTEL
6 (152) MANTEL
4 (102) MANTEL
4
(102)
14
(356)
12
(305)
10
(254)
2 (51) MANTEL
TOP OF
APPLIANCE
6
(152)
NOTE - Hood shown as positioned
in louvered front model. The hood
position in the flush faced front model
is lower than shown.
8
(203)
MANTEL CLEARANCES
Inches (mm)
detsiL tneVeruceS stnenopmoC™
.taC
.oN
.oNledoMnoitpircseD
59L68RTH5.4VSnoitanimreTdnuoRlatnoziroH
)08K69(recapS/potseriFhtiw
)16L47(retpadAdna
72L89LSSTH5.4VSerauqSllamSgnoLlatnoziroH
htiwnoitanimreT
dna)08K69(recapS/potseriF
noitcestnev)mm503(.ni21
)17L77(
79L68STH5.4VSnoitanimreTerauqSlatnoziroH
)08K69(recapS/potseriFhtiw
)16L47(retpadAdna
01L49SSTH5.4VSerauqStrohSlatnoziroH
htiwnoitanimreT
dna)08K69(recapS/potseriF
)16L47(retpadA
2512H1-VGC5.4VSnoitanimreTlacitreV
Figure 58
COLD CLIMATE INSULATION
If you live in a cold climate, seal all cracks around your appliance with noncombustible material and wherever cold air could enter the room. It is especially
important to insulate outside chase cavity between studs and under floor on which appliance rests, if floor is above ground level.
A hearth extension is not required with this appliance. If a hearth extension is used, do not block the lower control compartment door. Any hearth
extension used is for appearance only and does not have to conform to standard hearth extension installation requirements.
Note: Combustible wall finish materials and/or surround materials must not be allowed to encroach the area defined by the appliance front face (black sheet
metal). Never allow combustible materials to be positioned in front of or overlapping the appliance front face. See Figures 55 and 56 on page 23.
Non-combustible materials, such as surrounds and other appliance trim, may be installed on the appliance front face with these exceptions: they
must not cover any portion of the glass or louvers; they may cover any portion of the top radiant panel or the air gaps surrounding the top radiant
panel up to the installed hood.
Vertical installation clearances to combustible mantels vary according to the depth of the mantel. (See
Figure 58
). Mantels constructed of non-
combustible materials may be installed at any height above the appliance opening; however, do not allow anything to hang below the hood.
INSTALLATION ACCESSORIES
17"
14"
Min. Distance To
Unprotected Side Wall
8 ¹⁄₄"
45°
Combustible Materials
Allowed In Shaded
Area “Safe Zone”
12"
5"
Min. Distance
To Protected
Side Wall
Top View Of
Fireplace
Side
Wall
Side
Wall
Combustible materials may project beyond the
sides of the fireplace opening as long as they
are kept within the shaded areas illustrated in
Figure 57
.
Figure 57