Sunbeam Bedding MF2000 2000W Electric Heater User Manual


 
Electronic thermostat
The electronic thermostat works with the
external temperature sensor to maintain your
selected temperature. It constantly monitors
the room’s temperature and continuously
varies the heat output to maintain your
desired comfort level.
Ceramic disc heating system
Each ceramic disc contains 1200 honeycomb
shaped holes that heat all of the air that
passes through them, generating air up
to 40% warmer than conventional coil or
ceramic chip heaters.
External temperature sensor
The temperature sensor is located at the rear
of the unit, not inside the heater itself, to
ensure accurate temperature measurement.
It detects even the slightest change in the
room’s temperature, and communicates
this to the electronic thermostat.
Tip over cut-out
Should your heater accidentally be
knocked over, the instant tip over cut will
automatically interrupt power to the heating
element and fan. The heater will not resume
operation until it is replaced in the upright
position.
Power/Mode light
The power light illuminates amber to
indicate that the heater is connected to the
power outlet and is set to AUTO mode. It
illuminates green when the heater is set to
MANUAL mode.

