Sunbeam HE2050 Electric Heater User Manual


 
7
Troubleshooting Guide
If your heater fails to operate check the
following:
Make sure the electrical outlet or circuit
breaker is working.
Check for obstructions. If you nd an
obstruction, turn the heater off and follow
the reset instructions in this section.
Check that the thermostat is not set too low.
Turn the thermostat dial clockwise.
Resetting the safety auto shutoff
Remove any blockage from the front or rear
grille.
Turn the mode selector dial to the Off
position.
Unplug the heater and wait 5-10 minutes for
the heater to cool down.
Once the heater has cooled down, plug the
heater into the power outlet and operate
normally.
1.
2.
3.
4.
sun_2050.indd Sec1:7 8/01/2008 22:23:18